line of crimping and cutting tools are provided
by the world's premium suppliers including Simonds and Master Power. You can trust
C.H. Reed to provide the right solution for your Crimping and Cutting Tools, every time. Contact
us for more specific information.Simonds / Master Power Crimping and Cutting Tools come in a wide variety of drive sizes and styles. We can also meet your "special" needs.
This miniature power pack is for use with the cutting, crimping and bending jaws found below. The tool is small (5” long x 1 1/4” diameter) and can be operated at air pressures of 60-80 psi, producing 100 lbs of end cutting force. A built - in adjusting screw controls the opening of the jaw sets. Jaw sets are sold separate.
The CM-3 Crimp-Master secures
solder - less terminals to solid or stranded, bare or insulated
wire, to meet most requirements of several MIL specifications.
It fits on to our SP-002 to SP-005 Power Packs (based on power
required for crimp), and features a durable aluminum housing with
hardened tool steel jaws. Most of the crimping is performed with
F style power packs.
The most prominent type of scalers are Inline Exhaust. The front Speed RPM is 4600. The weight lbs is 6.3 and in kgs is 2.9. The length is 15.0 in inches and in mm is 381. The termination round nose bore is 1.0 in inches. The stroke is 1.1 in inches and 28 in mm.
The Chisels capacity ranges from .75 in Bore - 1.9 in Stroke. The speed RPM is 4000 Blows / Minute. Pistol Grip is one of the prominent type of chisels. The weight in lbs is 3.4 and in kgs is 1.5. The length is upto 178mm. The side to center is 13 / 32 in inches and 27.8 in mm.